Can a bad PCM cause transmission problems?

Does the PCM control the transmission?

The powertrain control module, aka PCM, is your vehicle’s brain. It manages the engine, transmission and other systems based on information it receives from various sensors around the vehicle.

What happens when a PCM goes bad?

Bad PCM Causes Engine performance issues. Engine misfiring or stalling and overall poor engine performance are common indications of problems with the engine control unit. Modern vehicles have various sensors that operate within a given range to ensure the intended functions of the engine.

How can you tell if a PCM is bad?

What Are the Symptoms of a Faulty PCM?

  1. Your “check engine” light is on.
  2. Other warning lights may be on, including traction control and ABS.
  3. You lose fuel economy for no apparent reason.
  4. Your car stutters when starting, requires multiple attempts, or won’t start at all.
  5. Stuttering or stalling during idling.

What are the symptoms of a bad PCM relay?

The failed PCM relay will turn off the dashboard lights and other key safety warning lights that are normally illuminated when you turn the key in the ignition. Furthermore, and more importantly, the vehicle will usually be unable to start, and it might be impossible to turn the key.

IT IS INTERESTING:  Can a person crack a windshield?

How much does it cost to fix a PCM?

The PCM controls more than 100 factors in your car, and for that reason, is very important – and expensive. A typical pcm replacement cost comes to between $500 and $1,500 on average.

Is a PCM and ECM the same thing?

The main difference between the two is that the ECM controls specific parts of the engine, regulating and sending commands. While the PCM is used in newer models to control almost all engine functions.

How do you know if you need a new PCM?

Continuing to run a vehicle with a bad PCM could cause further damage. Because the PCM controls the emissions of your car, a failed emissions test or the presence of oddly-colored or foul smelling exhaust may be a sign that your PCM is going bad. A malfunctioning PCM will activate dashboard error lights.

How long does it take to replace a PCM?

How long does it take to replace a PCM? The process takes around about half an hour, but keep in mind that most auto-electricians charge you for at least one hour of work. PCM reprogramming is also one of the few times we’ll recommend a dealership over an independent mechanic.

Will a bad PCM throw a code?

The PCM should give you a code for P0600 through P0606 indicating that the computer has a processor error. However, if the PCM is corrupt, then just like a desktop computer, there is no accessing anything and no codes are put out for the computer would have no way of sending a signal.

How do you troubleshoot a PCM?

How to Troubleshoot the PCM

  1. Locate your vehicle’s PCM. …
  2. Look specifically at the wiring harness. …
  3. Locate your vehicle’s diagnostic data port. …
  4. Connect your OBD-II scanner to the diagnostic data port.
  5. Push your key into the vehicle’s ignition cylinder. …
  6. Watch the OBD-II device’s read-out screen for the codes.
IT IS INTERESTING:  Quick Answer: Does AutoZone do a free diagnosis?

How do you reset a PCM?

Resetting the PCM on your vehicle will help to clear all codes from it after a problem is fixed.

  1. Open the hood of the vehicle.
  2. Disconnect the negative battery cable from the battery. Use a wrench to loosen the lock nut, and pull the cable off. This cuts the power to the PCM. Wait for five minutes.