# Can you run a 12v motor on 6v?

Contents

## What happens when you put 12V to a 6v motor?

It will spin very fast and could burn out the motor if it can;t handle the extra volts. you can get a voltage regulator for it.

## Can I run a 12V motor on 5v?

A motor in itself can run at any voltage up to its rated voltage (and beyond provided a heat sink is added).

## Can a 12V motor run on 18V?

Since 12V lead-acid batteries were originally designed for cars, there is a lot stuff that runs this way. 18V would be risky, I would not try to plug a 12V device into an 18V battery. But if you happen to have 18V for whatever reason, you can always use a DC-DC converter.

## How do I convert 12V to 6V?

It’s possible to step 12 volts down to 6 volts by incorporating a pair of 10,000-ohm resistors into the circuit. Cut two lengths of wire, and strip each wire of 1/2 inch of insulation at each end. Attach one end of the first wire to the positive terminal on the power supply.

## Can you replace a 6V battery with a 12V?

You don’t want to connect the 6-volt motor directly to the 12-volt battery because chances are you will burn out the motor. Some 6V converters work just fine with a 12-volt battery.

IT IS INTERESTING:  How fast is a 10 horsepower motor?

## Can a 9V battery run on a 12V motor?

The 9V batteries are weak because the other half of the story is how much current they can supply. … It’s possible to run a 12V motor on 9V, but it will run slower and with less Torque.

## Can you run a 12 volt motor on 24 volts?

Therefore, provided you chose a controller suitable for the motor you use, you can usually run a motor 12v motor from a 24v battery with no effect except that full speed is doubled.

## How much voltage does a DC motor need?

Typical DC motors may operate on as few as 1.5 Volts or up to 100 Volts or more. Roboticists often use motors that operate on 6, 12, or 24 volts because most robots are battery powered, and batteries are typically available with these values. Operating Current.

## Can I use an 18V battery in a 20V drill?

There is no reason the 18V tool can’t run on 20V without an intermediary circuit. … As long as the Lithium batteries are charged on a DeWalt lithium charger you are safe and the tools will run fine on 19 volts – the actual no-load voltage of a charged DeWalt lithium battery.