How does PLC control DC motor speed?

What are the factors that control the speed of a DC motor?

The above equation shows that the speed depends upon the supply voltage V, the armature circuit resistance Ra, and the field flux Ф, which is produced by the field current. In practice, the variation of these three factors is used for speed control.

How does a PLC control a motor?

A PLC has to start a Motor when the Start button is pressed. It has three interlocks which are Motor Vibration High, Overload & Motor Temperature High. if any of the interlock activated then PLC has to stop the motor immediately. PLC has to stop the motor if the stop button is pressed.

What is the speed of dc motor?

DC controls adjust speed by varying the voltage sent to the motor (this differs from AC motor controls which adjust the line frequency to the motor). Typical no load or synchronous speeds for an AC fractional horsepower motor are 1800 or 3600 rpm, and 1000-5000 rpm for DC fractional hp motors.

When the speed of DC motor is increased?

From the equation. (3) we can say, speed is inversely proportional to armature current. Thus, when the speed of the dc motor is increased, the armature current will decrease. So, the correct answer is “Option B”.

IT IS INTERESTING:  How early can you service your car?

Can a DC motor turn both ways?

DC motors, like AC motors, can be configured to turn in either direction. Their direction can be easily controlled by inverting the polarity of the applied armature voltage by reversing the armature leads.

What are the 3 types of DC motors?

There are 3 main types of DC motor that are available:- Series, Shunt and Compound. These terms relate to the type of connection of the field windings with respect to the armature circuit.

What is the maximum speed of DC motor?

The nominal maximum speed and power are 24000 RPM and 0.815 HP. In particular, these machines must operate loaded in order to avoid damage.

What is the maximum RPM of a DC motor?

25,000rpm motor dc 12v has acquired the highest response among electronics hobbyists for high speed operations.