Which DC motor Cannot be started on no load?

Which DC motor should not be started at no load?

Speed of DC Series Motor ωm = Very high, which is also clear from the Speed Current Characteristics of DC Series Motor as shown in figure above. Therefore if the DC Series Motor is started at No Load then the speed of DC Series Motor will become dangerously high which will definitely damage the DC Series Motor.

Which motor does not start at no load condition?

This can be seen from the speed-armature current and the speed-torque characteristics that on low armature current and low torque condition motor shows a tendency to rotate with dangerously high speed. This is the reason why series motor should never be started on light loads or no load conditions.

Which of the following motor should not be started on no load?

Since speed is constant and torque (τ) is proportional to armature current (Ia). So that, starting a shunt motor at a heavy load requires a high starting current. In order to avoid this high starting current, shunt motors are not started at heavy loads and they should be started without any load.

IT IS INTERESTING:  What does a v6 engine mean?

Which DC motor has maximum self loading property?

Which DC motor has got maximum self-loading property? Explanation: A differentially compound DC motor, flux reduces so sharply at small increase in load at higher values of load.

What is no load current in DC motor?

The no-load current is the current required just to turn the motor shaft with nothing connected. It is the current required to overcome the bearing and brush friction plus the aerodynamic drag caused by the rotor moving in the air and moving air through the motor for cooling purposes.

Can you start a series motor without load if no why?

A series motor should never be started at no load. With no mechanical load on the series motor, the current is low, the counter-EMF produced by the field winding is weak, and so the armature must turn faster to produce sufficient counter-EMF to balance the supply voltage. The motor can be damaged by overspeed.

What is the ideal no load speed for a series DC motor?

Explanation: At no load, armature current tends to zero, flux φ tends to zero, where speed is inversely proportional to the flux, speed will tend to infinity. Thus, no load speed of DC series motor is highest.

Which motor has the poorest speed control?

1. Which of the following DC motor has the poorest speed control? Explanation: DC series motor at no load condition gives infinite speed ideally. Practically it will damage all the armature circuit.

Which DC motor has self relieving property?

Which DC motor has got maximum self-relieving property? Explanation: DC series motor develops large starting torque initially and slow down with increase in load and so get automatically relived from heavy excessive load. Thus, DC series motor is called as self-reliving machine.

IT IS INTERESTING:  How long can I leave my car without service?

What is the speed of DC motor?

DC controls adjust speed by varying the voltage sent to the motor (this differs from AC motor controls which adjust the line frequency to the motor). Typical no load or synchronous speeds for an AC fractional horsepower motor are 1800 or 3600 rpm, and 1000-5000 rpm for DC fractional hp motors.

Which DC motor is preferred for constant speed?

DC Shunt-wound motor: This is an almost constant speed motor and its torque varies nearly as the current.

Which power is mentioned on a nameplate of a dc motor?

8. Which power is mentioned on a name plate of a motor? Explanation: Name plate of the motor shows rated values i.e. rated speed, rated current, rated voltage. It also shows output power available at shaft when all other quantities are set to rated values.

Why does dc motor sometimes run too fast when under loaded?

Explanation: As the field resistance increases the speed decreases. … Explanation: For armature voltage control, armature current is increased so as to reduce speed below base speed. In field control flux is reduced so the speed would be above base speed.