Why does my trolling motor run backwards?

How do you reverse polarity on a trolling motor?

another way to reverse it is take the screws out that hold the head on,turn it one hundred eighty degrees and put the screws back in. You can also reverse the magnetic field in the motor by removing the two long bolts behind the prop and rotating the housing 180 degrees.

Why does my trolling motor only work in reverse?

The motor is a DC unit, reverse is achieved by switching the polarity ( positive and negative) going down to the motor in the housing in front of the prop. If you have reverse you didn’t fry the unit, and should be an easy fix to find and repair forward.

Can a trolling motor go in reverse?

Not all trolling motors can go in reverse, and that’s okay. Most bow mount trolling motors can’t go in reverse but can turn 180 degrees. On the other hand, most transom mount trolling motors need to go in reverse to avoid damaging the propellers by attempting to turn.

Which way should a trolling motor prop turn?

You can tell by looking at the way the prop is made to pull in the water. It is correct. Motor turn counter clockwise to to move forward.

IT IS INTERESTING:  Does flood damage affect car engine?

Can you turn the handle around on a Minn Kota trolling motor?

Yes, by removing the screw and nut at the base of the control box the control box can be turned 180 degrees on the motor tube, then reinstall the locating screw and nut (being careful not to pinch or damage the motor wires inside the tube), tighten the screw and nut as required, and the job is complete.

How do you troubleshoot a Motorguide trolling motor?

Start by inspecting your electrical system to ensure power is reaching the motor. Check the connections at the battery terminals and the trolling motor. Clean battery posts with a wire brush when you discover corrosion and grime. Check the voltage on the battery, and replace if the battery will not hold a full charge.

Can you adjust depth of trolling motor?

Raise or lower the depth of the trolling motor. Do not set the motor depth so low that it compresses the coiled cable. When the coiled cable is compressed, it will be damaged by friction as the motor steers, and may cause unexpected movement when using the anchor lock feature.

How do you adjust the depth of a trolling motor?

Choosing the correct trolling motor shaft length is important so that the angler’s electric motor does not cavitate, creating fish-spooking noise. The rule of thumb is that the top of the motor section should be submerged 12″.