Your question: How do I identify a Ford 352 engine?

How do I identify a Ford 352?

You can tell the date it was made by the date cast next to the oil filter adapter. and you might find casting dates on the heads and intake too. If the dates on the block and heads are from 1965 then you probably have a 352, if they’re later then it’s probably a 360.

How do you tell the difference between a Ford 352 360 and 390?

Re: 390/360/352 what’s the difference? Make the bore bigger, that “cylinder” displaces more room, OR make the stroke longer, and that cylinder also displaces more area. A 390 uses the bigger bore of a 360, PLUS the added stroke of 3.78 inches.

What engine is a 352?

Description

Displacement Type Stroke+/-0.004
332 cu in (5.4 L) FE 3.3 in (83.8 mm)
352 cu in (5.8 L) 3.5 in (88.9 mm)
359 cu in (5.9 L) FT
360 cu in (5.9 L) FE

What’s the difference between a 360 and a 390 Ford engine?

If the engine came out of a truck or pickup, it is very likely a 360 engine, as 360s had a higher torque rating and sturdier internal parts, making them ideal for trucks. 390 engines had less torque, but higher horsepower, making for better performance in cars.

IT IS INTERESTING:  Does Advance Auto Parts install headlight bulbs?

Is a Ford 360 a good motor?

The 360 was a very good engine, no different than the 390. A bit les horsepower, however. The biggest issue witht he 360 was that it offered roughly the same power as the 302 at the time, with much worse efficiency.

Are Ford 360 and 390 heads the same?

the only difference between a 360 and 390 is crank, rods, and pistons.

Is a 352 a good engine?

In the day, the 352 was the “Intercepter Special V8” motor used by police departments everywhere. If you’re talking about one of the Ford FE engine 352s (made from 1958 to 1976), then yes, it’s a very good engine.

When did Ford stop making the 352 engine?

The 352 engine was utilized from 1958 through 1967 in vehicles ranging from police interceptors to family cars and pickups. The 352’s 10-year production run was a result of its strength and durability.

What does FE stand for in Ford engines?

FE (which means “Ford Engine,” not Ford-Edsel, nor Ford Engineering) variety comes from a broad selection of bore and stroke sizes to achieve cubic-inch displacements. The 332 and 352 are fraternal twins, virtually identical engines with 4.00-inch bores.

How can you tell the difference between a 429 and a 460?

One way to identify 429 vs 460 is to flip the motor over and unbutton the pan. One of the crankshaft counterweights (3rd down from the crank snout) has alphanumeric markings stamped on it’s edge, and these markings identify whether it’s a 429 or 460 crankshaft.

How do I know what 360 engine I have?

crawl under the car on the drivers side look above the starter there will be a number the last 4 didgets will be for example 340-5 or 360-3 or 318-1 the last number could be from 1 to 9 i hope vthis will make it easier for you.

IT IS INTERESTING:  Can you charge a car battery while still connected?

What’s the difference between a 390 and a 427?

The 390 has a 4.05″ bore and a 3.78″ stroke. good low end torque motor. The 427 has a 4.23″ bore and a 3.78″ stroke. Great high rpm motor.